Q. What size do I need?
A. That depends on your vehicle. Click the "Do they fit my car?" link.
Q. How much of the lock is covered?
A. SmoothLocks cover the flat face of the lock. It does not cover any area between the face of the lock and the vehicle. If you paint your SmoothLocks to match your car, you may have to paint part of the lock, depending on your sytle of lock.
Q. How do I apply them to my locks?
A. It only takes a few moments to apply a SmoothLock. First, thoroughly clean the lock surface and ensure there it is free from grease or dirt. Then apply the Smoothlock simply by peeling it from the backing paper and then place it on the lock surface.
Q. What if I need to remove them?
A. If you need to remove your SmoothLocks, simply peel them off. The adhesive is very strong, and this might take a bit of effort and care (especially if you painted your SmoothLocks, the paint may crack if you are not careful removing them).
Q. Can I paint them to match my car?
A. Yes, they can be painted to match your car. If you want to paint yours, you need to make sure the paint will stick to the SmoothLock. We suggest using a clear primer such as Klean-Strip Adhesion Promoter or similar product. Once the primer has dried, you can paint the SmoothLocks.
TIP: Once the paint dries, use a very sharp X-Acto knife to trim around the edge of the SmoothLock. This will make it easier to remove it from the backing paper without cracking the paint.
Q. What is the thin white layer between the SmoothLock and the adhesive?
A. If you are not painting yours and are leaving them black, you will notice a very thin white line around the base of the SmoothLock. This is to make sure the adhesive doesn't detach. If you like, you can take the flat edge of a black magic marker and carefully run it around the edge of the SmoothLock to cover up the white line before you install it.
Q. I think my SmoothLock is coming loose. What do I do?
A. We use some pretty touch adhesive but if you ever feel that a SmoothLock is losing its adhesive grip, carefully remove it completely, clean the lock surface yhoroughly, place a very thin layer of clear silicone automotive adhesive on the back of the SmoothLock and replace.
Q. Can I order from you direct?
A. Yes, by ordering from CZ28Store.Com
Q. What is the SmoothLock warranty information?
A. I stand by this product 100%. If it is not to your satisfaction you may return it for a full refund as long as it is unused and in new condition. Unfortunatlely, there are no returns/refunds due to theft, damage, misuse, modification (including painting), and installation. If ordering from a dealer, please review their return policies as they may vary.
Q. Can I put a SmoothLock banner on my car site?
A. Sure, and it would be appreciated! You can get banners here.
If you have a question that is not answered here, feel free to . |
|
